Current Concepts With Video Illustration
The Geometric Classification of Rotator Cuff Tears: A System Linking Tear Pattern to Treatment and Prognosis

https://doi.org/10.1016/j.arthro.2009.07.009Get rights and content

Abstract

A valuable classification system allows for communication among surgeons and/or other investigators and offers information on treatment and prognosis. It provides a means for comparison of epidemiologic data and treatment outcomes. There is no current standard classification for rotator cuff tears. Authors and practicing orthopaedists use a variety of descriptions when communicating about cuff tears. Older classifications do not use 3-dimensional information derived from the present use of arthroscopy and magnetic resonance imaging. The new geometric classification offers guidance on treatment and prognosis. Type 1, crescent-shaped tears are repaired end to bone and have a good to excellent prognosis. Type 2, longitudinal (L- or U-shaped) tears are repaired side to side with margin convergence and have a good to excellent prognosis. Type 3, massive contracted tears have coronal and sagittal dimensions greater than 2 × 2 cm on preoperative magnetic resonance imaging; are repaired with interval slides or partial repair; and have a fair to good prognosis. Type 4, rotator cuff arthropathy tears have end-stage degenerative changes of the glenohumeral joint and have articulation of the humeral head with the undersurface of the acromion; are irreparable; and require arthroplasty if surgery is considered. This classification describes complete tears of the superior and posterior rotator cuff, supraspinatus, infraspinatus, and teres minor. Additional notation can be made regarding the presence of related pathology including tears of the subscapularis, biceps, or labrum; instability or arthritic change of the glenohumeral or acromioclavicular joints; or fatty degeneration of the cuff.

Section snippets

Rotator Cuff Geometric Tear Patterns, Methods of Repair, and Prognosis

The geometric classification has 4 types (Table 2). Type 1, crescent-shaped tears are relatively short and wide.5, 6, 7, 8 The medial-to-lateral length of these tears is less than the anterior-to-posterior width. Type 1 tears are typically mobile from medial to lateral and can usually be repaired by fixing the tendon end directly to the bone bed on the greater humeral tuberosity (Fig 1). It has been shown that repair of crescent-shaped tears with end-to-bone techniques results in good to

Discussion

The geometric classification of rotator cuff tears will help orthopaedic surgeons communicate about tears of the supraspinatus, infraspinatus, and teres minor based on tear pattern recognition (Video 1, available at www.arthroscopyjournal.org). It provides important guidance for treatment and prognosis for each type of tear. The previous studies providing the foundation for this classification were performed by the same surgeon (S.S.B.) and assessed results by means of the same modified UCLA

References (26)

Cited by (158)

  • Rotator Cuff Tears Are Related to the Side Sleeping Position

    2024, Arthroscopy, Sports Medicine, and Rehabilitation
View all citing articles on Scopus

The authors report no conflict of interest.

Note: To access the video accompanying this report, visit the March issue of Arthroscopy at www.arthroscopyjournal.org.

View full text